BIS 261 Week 1 ilab
Click Link Below To Buy:
Contact
Us:
Hwcoursehelp@gmail.com
Please
you only accept the assignment if you can do in 4 hours and 30 mnts
STEP 1: Review background
information
Review
the case study on Acme Medical Data Storage LLC, given in the Scenario/Summary
section above, paying careful attention to the characteristics of the company
and its IS projects.
NOTE:
This is an individual, not a team, iLab.
In your
review, make notes specifying how you would rate the following characteristics
of the company and project. These notes will not be turned in, but you will use
them in conducting your analysis in Step 2 and preparing your memo in Step 3.
1. Is theproject technologyextremely stable, moderately
stable, or experimental?
2. At the
start of the project, are theproject
requirementswell known, partially known, or mostly unknown (i.e.,
experimental)?
3. Is theproject domainheavily regulated, moderately
regulated, or lightly regulated by government or other outside agencies?
4. Is thesize of the organizationlarge, mid-sized, or small?
5. Is theorganizational culturebureaucratic, mixed, or
entrepreneurial?
6. Is theorganization's competitive environmentslow-paced,
moderately paced, or fast-paced?
STEP 2: Analyze SDLC suitability
Based on
the information given in the case study, analyze the suitability of a specific
Software Development Life Cycle (SDLC) model for Acme Medical Data Storage LLC:
·
If the last digit of your DSI Number is 0, 1, 2, or 3, use theWaterfall SDLC;
·
If the last digit of your DSI Number is4, 5, or 6, use theUnified
Process; and
·
If the last digit of your DSI Number is 7, 8, or 9, use anagile SDLC (Scrum or XP).
In your
analysis, examine your notes from your review of the project and organizational
characteristics from Step 1, and make additional notes on the following points.
These notes will not be turned in, but you will use them in preparing your memo
in Step 3.
1. Is theproject technology a good or a poor fit for this SDLC
model? (Recall from your reading that good fits are stable technology and
waterfall; moderately stable technology and UP; and experimental technology and
agile.)
2. Is the knowledge of project requirementsa good or
a poor fit for this SDLC model? (Recall from your reading that well-known
requirements are a good fit for waterfall; partially known requirements are a
good fit for UP; and mostly unknown requirements are a good fit for agile.)
3. Is the degree of regulation of the project domaina good or
a poor fit for this SDLC model? (Heavy regulation is a good fit for waterfall;
moderate regulation, for UP; and light regulation for agile.)
4. Is thesize of the organizationa good or a poor fit for this SDLC
model? (Good fits, generally, are large organizations and waterfall; mid size
organizations and UP; and small organizations and agile.)
5. Is theorganizational culturea good or a poor fit for this SDLC
model? (Good fits are bureaucratic organizations and waterfall; mixed organizations
and UP; and entrepreneurial organizations and agile.)
6. Is theorganization's competitive environmenta good or
a poor fit for this SDLC model? (Good fits are slow-paced and waterfall;
moderately paced and UP; and fast-paced and agile).
STEP 3: Write memo to Bill
Write a
one-to-two page memo to CIO, Bill Doors, by doing the following steps.
1. Download
theBIS261_W1_iLab_Template.docxtemplate
file from the iLab Filesfolder in
Doc Sharing.
2. In the
memo header, enter your name in theFromfield;
enter the current date in theDatefield.
3. In the
Introduction section, fill in the SDLC model that you are writing about in the
blank (waterfall, Unified Process, or agile).
4. In theDescription of the SDLC Modelsection, briefly describe
the SDLC model that you are writing about in the memo. Refer to any reading
assignment in the textbook and to the Lecture for information about this SDLC
model, then describe it in your own words; don't copy the description word for
word from the textbook, the Lecture, or another source.
5. In the Pros
for this SDLC Model section, list and briefly explain the factors that are
favorable toward Acme adopting this SDLC model. These should be chosen from the
factors that you identified as good fits for the SDLC model in your analysis in
Step 2. You should write about at least one, but no more than three, favorable
factors. If you identified more than three factors as good fits for the SDLC
model, choose what you believe are the three most important ones to include in
your memo.
6. In the
Cons for this SDLC Model section, list and briefly explain the factors that are
unfavorable toward Acme adopting this SDLC model. They should be chosen from
the factors that you identified as poor fits for the SDLC model in your
analysis in Step 2. You should write about at least one, but no more than
three, unfavorable factors. If you identified more than three factors as poor
fits for the SDLC model, choose what you believe are the three most important
ones to include in your memo.
In your
explanation of the favorable and unfavorable factors, refer to specific
characteristics of Acme's organization and its projects that impact the SDLC
model. You must make your analysis specific to Acme and its projects. Do not
just write about the pros and cons of your SDLC model in general!
Be sure
to cite any sources that you use, using the citation style given in the
Syllabus.
STEP 4: Save and submit
Save
your memo as a Microsoft Word file using the following naming convention:LastName_w1_ilab.docx.
Submit
your assignment to the Dropbox, located at the top of this page. For
instructions on how to use the Dropbox, read these step-by-step
instructions.
System
Analysis and Design Project
Name
Institution
Systems
Analysis and Design Report for Acme
Introduction
The important concerns of Acme’s
system analysis and design are the monitoring of success or failure of the
system. There is a correlation of general system analysis and design best
performances to the system successes. The system analysis project analyzes the
system analysis and design best practices found in existing information system
(IS) literature. The practices studied by IS researchers are compared to the
practices proposed by the IS practitioners. The findings from the study confirm
that many best practices such as
consumer participation, executive management sustenance, clear statement of
requirement, proper planning, realistic expectations and proper planning are
challenging in the society (Dennis
& Roth, 2014.
1. Description of Acme
During the development of the system
design analysis, various organizations use standard steps called the system
development life cycle (SDLC). It is used as a structured and common
methodology for system development. The structure has four stages such as the
planning, analysis, design, implementation, and maintenance. The stages have
various advantages and disadvantages in a way that could be used to fit and
optimize various kinds of projects in Acme.
Size of the organization
The Acme organization is large enough to fit
SDLC model with employees about one million
Acme’s Environment
Analysis
of Acme’s external environment entails the customers, competitors, technology,
and social issues. With regards to customers, Acme has a large base of
customers. For example, at least one quarter a million customers per week visit
Acme. This can be attributable to the low prices with which Wal-Mart offers to
its customers. Wal-Mart also offers a wide variety of merchandise in comparison
to the other retailers (Cummings & Worley, 2004).
Organizational culture
The company has built an
effective communication plan that explaining its objectives as well as
rationale, the period and the cost of not changing. It does the Implement the
communication plan timely and communicates often. The organization also sends
out recurrent progress apprises. Focus the organization’s devotion forward and
create an excitement about the new modifications to the SDLC.
Pros of SDLC
There are various problems facing
the company for its perfect performance or deliverance to Acme. The slow
running of the system at the peak hours during the morning and the afternoon
hours influences the tasks performed by the Acme representatives. The
technology in not up to date since it misses places to insert the email
addresses possessed by many customers since in improves customer service
operations.
Cons of SLDC
There is no immediate record of various
transactions performed at the company and the data about the most recent
transactions, and the previous should be kept in the database. There is
difficulty in the tracking of the customers who are lagging behind in their
payments and it would be perfect if the problems are solved (Dennis & Tegarden, 2015).
There is also the lack of the software tracking the potential customers
purchasing behavior within the company, but the user applies the use of
databases.
There are positive impacts in the
addressing of the problems and the opportunities facing the SLDC. The improvements of the slow running
systems during the peak hours would improve the company output since many
customers would be served at a short time. The improvement of the customer
details insertion system would store all the information about the potential
customers within the company to enable easy tracking.
2. Analysis
The
analysis involves the identification of problems, and the possible
recommendations and solutions for the problems in the Acme. System analysis
gathers
No comments:
Post a Comment